|
Post by ~ADC~ on Aug 18, 2007 19:22:36 GMT -5
I made mine from ½" round rod. It is about 20" long and the two ends are about 1 ½" long the T-bar handle is about 6" long. All it really does is give you a very good handle to pull on the stakes. I heat the rod to make the bends and it is important to make the one bend on the main rod less than 90 degrees so it actually points up a little. It is also important to be sure the T handle and the bends are oriented the same as the picture. That way you can swing it into the ground at the stake, it goes right under and makes pulling them very easy. Sometimes I have to hit the stakes down a little to break the frost then hook this under and they pull easy. ~ADC~
|
|