Cheap Catch Pole

[~ADC~]

I’ll try to describe the one I built… I took a 5-foot piece of metal conduit about 1 inch OD. Then I took a hacksaw and holding the conduit up and down I sawed a notch in the end about 1 ½” deep and wide enough for a small chain link to fit in it. Then I got a 6 foot piece of chain (small dog chain) and a 2’ piece of 1/8" cable. I attached one end of the cable to one end of the chain by running it through the last chain link and using a 1/4" nut mashed on the cable. Then using a drill, drill a small hole through the side of the conduit 1” from the opposite end you cut the notches in. run the other end of the cable through this hole and use a single ferrule to attach the cable to this hole. Then drop the chain back through the conduit. This will leave a cable loop at one end and the chain sticking out the other end of the conduit. To catch the animal, put the loop over the animals neck pull the chain and hook it in the notch on the back of the pole. To release them pull the chain out of the notch and let it slip back through the conduit.

This little cheap pole is great for releasing small critters you don’t want to kill.

I’m sure that’s all clear as mud. Here are some pictures....








Here it is in action releasing an otter...





~ADC~